Installing the X-Symphony card
Install the X-Symphony Coverplate, and
6
secure it to the host interface using two
screws from Step 2.
Insert the Port connector end of the X-Symphony card through the appropriate cutouts
7
in the coverplate, and carefully place the multi-pin motherboard connector in the mating
connector found on the host interface motherboard.
After verifying the alignment of the multi-pin and the mating connectors, firmly press
8
down on the X-Symphony card, over the connector, until the pins are completely seated
in the mating connector.
9
Re-install the circuit board screws from Step 3 in
the locations indicated below.
10
Replace the top cover of the host interface.
Symphony Mobile – User's Guide
6
9
Installing the X-Symphony card
17