AOpen MX4SG-N Online Manual page 82

M X 4 S G - N / M X 4 S G - L O n l i n e M a n u a l
M X 4 S G - N / M X 4 S G - L O n l i n e M a n u a l
Windows 98SE Installation Guide
***************************************************
Installing Drivers During Windows 98SE Installation
***************************************************
Please refer to Windows 2000 USB2.0 installation guide. The installation procedures are the same.
*********************************************
Installing Drivers with Existing Windows 98SE
*********************************************
The following section details the installation of USB 2.0 driver on a system that has Windows 98SE already installed.
1. Enable the USB 2.0 controller and boot Windows.
2. The "Add New Hardware Wizard" will appear, informing you that it has found a "PCI Universal Serial Bus."
3. Click on "Next," and from the generated list box, choose "Search for best driver for your device (Recommended)".
4. Insert the "Bonus CD" in CD-ROM.
5. Click on "Next," and from the generated choices, choose "Specify a location."
6. Type "[CD-ROM]:\Driver\Intel\USB2.0\Win98ME" in the text box that appears.
7. Click on "Next." A message informing you that Windows has found "Intel USB 2.0 Enhanced Host Controller" should appear.
8. Click on "Next," and then on "Finish."
**********************************************
Confirming Driver Installation in Windows 98SE
**********************************************
To confirm that the driver has been properly loaded in Windows 98SE, perform the following steps:
1. Choose "Settings" from the "Start" menu.
2. Choose "Control Panel," and then double-click on the "System" icon.
3. Choose the "Device Manager" tab, and then click the "+" in front of "Universal Serial Bus Controllers." "Intel USB 2.0 Enhanced Host
Controller" should appear.
82