Advertisement
M
X
3
W
M
X
3
W
IDE1 is also known as the primary channel and IDE2 as the secondary channel. Each channel
supports two IDE devices that make a total of four devices. In order to work together, the two
devices on each channel must be set differently to master and slave mode. Either one can be the
hard disk or the CDROM. The setting as master or slave mode depends on the jumper on your IDE
device, so please refer to your hard disk and CDROM manual accordingly.
Warning: The specification of the IDE cable is a
maximum of 46cm (18 inches), make sure your cable
does not exceed this length.
Tip: For better signal quality, it is recommended to
set the far end side device to master mode and
follow the suggested sequence to install your new
device. Please refer to above diagram.
26
O
n
l
i
n
e
M
a
n
u
O
n
l
i
n
e
M
a
n
u
A
a
l
a
l
Open
Advertisement
