Table of Contents
Advertisement
A
K
7
7
-
4
0
0
/
A
K
A
K
7
7
-
4
0
0
/
A
K
continue to the next step -
7. From the Windows XP Setup screen, press the Enter key. Setup will now load all device files and then continue the Windows
XP installation.
***********************************************
Installing Driver in Existing Windows XP System
***********************************************
WARNING: If you will be moving the boot drive containing the existing Windows XP operating system to the SATA150 connector,
the SATA150 driver MUST be loaded on to this hard drive while it is still attached to your existing hard drive
controller. Do not attach this drive or any other hard drive to the SATA150 controller before completing this step.
After enabling the SATA150, Windows XP setup will show a "Found New Hardware" dialog box. Under Windows XP, "Mass
Storage Controller" will be displayed.
1. Click on "Next," and from the generated list box, choose "Install from a list or special location (Advanced)"
2. Click on "Next," and from the generated choices, choose "Include this location in the search:"
3. Insert the Promise SATA150 driver diskette into drive A:.
4. Type "A:\" in the text box that appears. Press " OK ".
3a. Insert the Bonus CD in CD-ROM.
4a. Type "[CD-ROM]:\Driver\Promise\SATA150\Driver\WinXP" in the text box that appears. Press " OK ".
5. Click on "Next." A message informing you that Windows XP has found "WinXP Promise SATA TX2plus (tm) IDE Controller"
should appear.
6. When the New Hardware Wizard has finished installing the Promise SATA150 software, click on "Finish"
7
7
-
4
0
0
N
/
A
K
7
7
7
7
-
4
0
0
N
/
A
K
7
7
-
4
0
0
M
a
x
-
4
0
0
M
a
x
95
O
n
l
i
n
e
M
a
n
u
a
l
O
n
l
i
n
e
M
a
n
u
a
l
Advertisement
Table of Contents
