Part Number And Serial Number; Model Name And Bios Version - AOpen MX4SGI-4DN2 Installation Manual

If you encounter any trouble to boot you system, follow the procedures
accordingly to resolve the problem.
Start
Turn off the power and unplug the AC power cable, then remove all
of the addon cards and cables, including VGA, IDE, FDD, COM1,
COM2 and Printer.
Make sure if the jumper settings for CPU and DRAMs are correct.
Clear CMOS, then plug the ATX power cord correctly.
(For P4 system, please also plug the 4pin(+12V) cord.
Install the VGA card. Then connect your monitor and keyboard.
Turn on the power, and check if
the power supply and CPU fan
work properly.
Yes
Check if there is display.
Yes
Press Ctrl, and Alt key at the
same time, hold them and then
press Del to see if the
system reboots.
Yes
During system rebooting, press Del to enter BIOS Setup. Choose
"Load Setup Default".
Turn off the system and
re-connect the IDE cable.
Check if the system can
reboot successfully.
Yes
Re-install Windows 95, Windows 98 or Windows NT.
End
No
The problem was probably caused
by power supply or motherboard
failure. Please contact your reseller
or local distributor for repairing.
No
Perhaps your VGA card or monitor
is defective.
No
It is very possible that your keyboard
is defective.
No
The problem should be caused by the
IDE cables or HDD itself.

Part Number and Serial Number

The Part Number and Serial number are printed on bar code label. You can find this
bar code label on the outside packing, on component side of PCB. For example:
Part No.
Part No.
P/N: 91.88110.201 is part number, S/N: 91949378KN73 is serial number.

Model name and BIOS version

Model name and BIOS version can be found on upper left corner of first boot screen
(POST screen). For example:
MX4SGI-4DL2 R1.00 Oct. 01. 2003 AOpen Inc.
Award Plug and Play BIOS Extension v1.0A
Copyright © 2003, Award Software, Inc.
MX4SGI-4DL2 is model name of motherboard; R1.00 is BIOS version
Serial No.
Serial No.