Table of Contents
Advertisement
A
K
7
9
D
-
4
0
0
M
a
A
K
7
9
D
-
4
0
0
M
a
5. Press "S" to use the driver on the floppy disk, and then press "enter" to continue with installation. If you press "enter" to use
"Windows default driver", you will encounter the following error message in the next phase of the installation: "Setup did not find
any hard disk drives installed in your computer"
NOTE: Restart installation and then use option "S" to load driver from floppy disk.
6. The Windows XP Setup screen will appear again saying, "Setup will load support for the following mass storage devices:" The
list will include "WinXP Promise SATA TX2plus (tm) IDE Controller".
NOTE: If you need to specify any additional devices to be installed, do so at this time. Once all devices are specified,
continue to the next step -
7. From the Windows XP Setup screen, press the Enter key. Setup will now load all device files and then continue the Windows
XP installation.
******************************************************
Installing Driver in Existing Windows XP System
******************************************************
WARNING: If you will be moving the boot drive containing the existing Windows XP operating system to the SATA150 connector,
the SATA150 driver MUST be loaded on to this hard drive while it is still attached to your existing hard drive
controller. Do not attach this drive or any other hard drive to the SATA150 controller before completing this step.
After enabling the SATA150, Windows XP setup will show a "Found New Hardware" dialog box. Under Windows XP, "Mass
Storage Controller" will be displayed.
1. Click on "Next," and from the generated list box, choose "Install from a list or special location (Advanced)"
2. Click on "Next," and from the generated choices, choose "Include this location in the search:"
x
x
77
O
n
l
i
n
e
M
a
n
u
a
l
O
n
l
i
n
e
M
a
n
u
a
l
Advertisement
Table of Contents
