Photometric Chart - American DJ TRIBAR Spot User Instructions

TRIBAR Spot
"+" or "-" to adjust the sound sensitivity. Press the Flash Button to
activate strobing and use the "+" & "-" buttons to adjust the strobe
speed.
SLAVE - This designates the fixture as a slave fixture in a master/
slave configuration.
SET ADDRESS - Press this button to set the DMX address. Press
this button first, then press the numbers to set the address. If all
LED's flash after entering the third number of the address, this indi-
cates that the DMX address is correct/okay, and it will automatically
go into DMX Mode. If the DMX address is wrong, the red LED's will
light up.
Example: Set DMX Address 1 Press "S-0-0-1"
Set DMX Address 245 Press "S-2-4-5"
R G B - Press either one of these buttons and the press the "+" or "-"
to adjust the brightness. Press the Flash Button to activate strobing
and use the "+" & "-" buttons to adjust the strobe speed.
"+" and "-" - Use these buttons to scroll through built in programs
and static colors, adjust the flash rate while strobing, adjust the
speed of the built in programs, adjust the sound sensitivity, and to
adjust the intensity of the RGB colors.
DMX Control:
Operating through an DMX controller gives the user the freedom to
create their own programs tailored to their own individual needs.
Follow the directions below to set your DMX Mode and address.
1. Before connecting to an DMX controller, your fixture has different
DMX channel modes, please select your desired mode by press-
ing the DMX Mode button, then using the "+" or "-" buttons to
scroll through the DMX Channel Modes. Set the mode before you
address the fixture. See the bottom of this page for the DMX
modes.
2. After you have selected your mode, set the DMX address for the
fixture by pressing the "S" button. When the "S" button is pressed
the LED's will flash 2-3 times. Use the number buttons to press in
your desired address. See "SET ADDRESS" on this page for ex-
amples.
ADJ Products, LLC - www.adj.com - TRIBAR Spot User Manual Page 13
ADJ LED RC Operation TRIBAR Spot
Note: When seeting the DMX address each time a number is pressed
a LED color will glow, when you have set the DMX address correctly
all LED's will flash 2-3 times.
3. Now you may connect the fixture via the XLR connections to any
standard DMX controller. Please see pages 15-22 to for a detailed
descriptions of the DMX modes, values, and traits.
• If the Red LED's glow you are in DMX Mode 1: 3 DMX Channels.
• If the Green LED's glow you are in DMX Mode 2: 5 DMX
Channels.
• If the Blue LED's glow you are in DMX Mode 3: 6 DMX Channels.
• If the Red & Green LED's glow you are in DMX Mode 4: 8 DMX
Channels.
• If the Red & Blue LED's glow you are in DMX Mode 5: The other
8 DMX Channel Mode.
• If the Green & Blue LED's glow you are in DMX Mode 6: 11 DMX
Channels.
• If all the LED's glow you are in DMX Mode 7: 20 DMX Channels.
TRIBAR Spot
ADJ Products, LLC - www.adj.com - TRIBAR Spot User Manual Page 14
ADJ LED RC Operation

Photometric Chart