Preparation - Alpine NVE-N852A Manual For Installation And Connections

1. Preparation

1
Check accessory parts.
(5 m)
GPS antenna Antenna
mounting plate
(2.5 m)
Power cable
1 Bracket
One each left and right
6 Spring 7 Flanged Hex
washer (M6) Nut (M6)
4
2
Prepare tools and mounting information.
Screwdriver
3
Park the vehicle in a safe and level location.
4
Apply the brake and remove the ignition key.
5
Mount the antenna on the roof.
Clean dust and oil at the mounting location and mount the antenna.
Notes:
The magnet of the antenna is very strong. Proceed cautiously to prevent any
damage to the vehicle's body. Keep the magnet away from articles susceptible
to magnetic fields such as credit cards, watches, etc.
Do not paint the antenna. Reception sensitivity may be decreased.
Mounting the antenna inside the vehicle.
1. Clean the mounting location.
2. Put on the antenna mounting plate.
3. Mount the antenna.
Notes:
Mount the antenna on a flat plane of the dash board or rear tray.
Some thermal reflection type or thermal absorption type glass may interrupt
high frequency waves. If reception is poor with the antenna installed inside the
car, try to mount the antenna outside the car.
3
Cable clamp
(4.5 m)
13P RGB extension cable (6 m)
2 Floor base 3 Screw with double
washer (M5
2
8 Wing Nut (M6) 9 Velcro
4
4
Electrical tape
2
Parking brake Solderless
aux. cord connector
Battery (AAA)
4 Hex bolt (M6
8)
4
! Velcro Tape
Fastener
2
Pliers Spanner
Remote Remote Control
Control Holder
2
5 Flanged self-tapping
50)
screw (M5 15)
4
" Self-tapping
Screw (M3
Pencil and eraser
Antenna
4
12)
4
Antenna
7