Performing Basic Configuration Tasks; Accessing The Oa-700 Through Cli - Alcatel-Lucent OmniAccess 700 (Vers. 2.2, 2.2-R02, 2.3) Getting Started Manual

Omniaccess 700 series
Hide thumbs Also See for OmniAccess 700 (Vers. 2.2, 2.2-R02, 2.3):
Table of Contents

Advertisement

Left running head:
Chapter name (automatic)

Performing Basic Configuration Tasks

P
B
ERFORMING
Once you boot the OA-700 and connect to the console, you can start configuring
your OA-700 either through the Command Line Interface (CLI) or the web-based
Graphical User Interface (GUI).
A
OA-700 T
CCESSING THE
The CLI is the primary interface to access the OA-700 through the console. The
CLI allows you to configure, monitor, troubleshoot the system, and enables
network connectivity.
To perform initial configuration of your system, follow the procedure given below:
Step 1: Once the system bootup is complete, you are asked to configure the
password for a special user - superadmin. Superadmin is authorized to execute
any command. You need to set the superadmin password when the following
prompt is displayed:
Enter the new password for superadmin:
Once you enter the password for the superadmin, you will be asked to reconfirm
the password, with the following prompt:
Retype the new password:
After confirming the password, you will be asked to login using a user name. The
below prompt appears.
Username:
Enter the user name as superadmin. Now, you will be prompted for a password.
Password:
Enter the newly configured superadmin password.
Note:
If you have any pre-existing user account, you can enter at the user name and
password prompts, else use the superadmin user account.
Step 2: After entering the correct user name and password, the ALU> prompt is
displayed. If the prompt is not seen, press the Enter key a few times.
ALU>
By default, the host name is "ALU". (To configure a different host name, use the
configure "hostname <name>' command in the Configuration mode.)
Step 3: At the ALU prompt, enter the enable command to enter the Super User
Mode (SUM).
Example:
ALU> enable
ALU#
12
Beta
C
ASIC
ONFIGURATION
CLI
HROUGH
Alcatel-Lucent
T
ASKS
OmniAccess 700 Getting Started Guide
Beta

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Omniaccess 740Omniaccess 780

Table of Contents