Entering Projector Information - Mitsubishi Electric UD8400U User Manual

8. ProjectorView

8.3. Entering projector information

(1) Click [SETUP] in the ProjectorView main window (PROJECTOR INFORMATION).
• Setup window is displayed.
<Note>
• Be sure to enter data within five minutes after the Setup window is displayed. Click OK to save changes.
The connection will turn off in five minutes after the window is displayed so you need to go back to the
main window (PROJECTOR INFORMATION) to access the Setup window.
(2) Enter data in each field, set Alert e-mail service to ON or OFF, choose Language between
Japanese and English, set Certification setting to ON or OFF, specify Password setting, and
choose to [RESET] Network setting reset.
<Note>
• When you change the Language setting, be sure to restart the ProjectorView for the changes to take effect.
The following table explains each item.
Item
Projector name
Installed date *
1
Installed location *
1
SMTP IP address *
2
E-mail address *
1
E-mail from *
1
Last lamp replaced date *
Last maintenance date *
Alert e-mail service
Language
Certification setting
Password setting
Network setting reset
* For data entry, use single-byte alphanumerical characters and symbols ( + - / = * _ ! ? . , : ; # $ % & ( ) | < > [ ] {
1
} " ' @ ).
* For data entry, use single-byte number characters and symbol ( . ).
2
Description
Enter a unique name to identity the projector.
Enter the date when the projector is installed.
Enter the place where the projector is located.
Enter the IP address of the SMTP server used for sending E-mails.
(e.g.192.168.0.1)
Enter the E-mail address to receive alert messages.
(e.g. administrator@xxx.xxx.xxx) (Up to 64 alphanumerical characters)
Enter the sender of alert messages. (e.g. PJView@xxx.xxx.xxx)
Enter the date when the last change of lamp was made.
1
nter the date when the last maintenance was done.
1
Choose whether to send alert messages.
Choose the display language of ProjectorView (Japanese or English).
Choose whether to set the network certification setting.
Click [PASSWORD] to access the network password setting window. (For
details, see "8.4. Setting the network password".)
Click [RESET] to access the network settings reset window. (For details, see
"8.5. Resetting the network settings".)
EN-23