Entering Projector Information - Mitsubishi Electric XL7100U User Manual

8. ProjectorView

8.3. Entering projector information

(1) Click [SETUP] in the ProjectorView main window (PROJECTOR INFORMATION).
• Setup window is displayed.
<Note>
• Be sure to enter data within five minutes after the Setup window is displayed. Click OK to save changes.
The connection will turn off in five minutes after the window is displayed so you need to go back to the
main window (PROJECTOR INFORMATION) to access the Setup window.
(2) Enter data in each field, choose Language between Japanese and English, set Certification
setting to ON or OFF, specify Password setting, and choose to [RESET] Network setting
reset.
<Note>
• When you change the Language setting, be sure to restart the ProjectorView for the changes to take effect.
The following table explains each item.
Item
Projector name
Installed date *
1
Installed location *
1
Last lamp replaced date
Last maintenance date *
Language
Certification setting
Password setting
Network setting reset
* For data entry, use single-byte alphanumerical characters and symbols ( + - / = * _ ! ? . , : ; # $ % & ( ) | < > [ ] {
1
} " ' @ ).
Description
Enter a unique name to identity the projector.
Enter the date when the projector is installed.
Enter the place where the projector is located.
Enter the date when the last change of lamp was made.
*1
Enter the date when the last maintenance was done.
1
Choose the display language of ProjectorView (Japanese or English).
Choose whether to set the network certification setting.
Click [PASSWORD] to access the network password setting window. (For
details, see "8.4. Setting the network password".)
Click [RESET] to access the network settings reset window. (For details, see
"8.5. Resetting the network settings".)
EN-23