Miele CVA 5060 Operating And Installation Manual page 65

... a message appears in the display
reminding you to fill or replace the
milk flask even though it is full and
positioned correctly.
^ Clean the flask thoroughly, paying
particular attention to the area around
the lid and the neck (see "Cleaning
and care - Stainless steel milk flask
with lid").
Any soiling in these areas can
prevent the sensors for the milk flask
from working properly.
... the coffee grinder makes a louder
noise than usual.
There may be stones in amongst the
coffee beans, or the bean container
may have emptied during grinding.
^ Switch the machine off immediately.
^ If the bean container is not empty
call the Miele Service Department. If
it is empty fill the container with fresh
beans.
... the espresso is dispensed too
quickly.
The coffee is too coarsely ground.
^ Set the grinder on a finer setting (see
"Setting the coffee grinder").
... the espresso is dispensed too
slowly.
The coffee is too finely ground.
^ Set the grinder on a coarser setting
(see "Setting the coffee grinder").
Problem solving guide
... the espresso is not hot enough.
^ Have the cups and system been
pre-warmed?
The smaller and thicker the cup, the
more important it is to pre-warm it.
^ Check the temperatures the different
types of coffee have been set to (see
"Settings: customising your machine -
Setting the temperature").
^ Check whether the brew unit is
blocked. If it is, clean it (see
"Cleaning and care - Brew unit").
... coffee is not dispensed, even
though the beans have been ground
and there is sufficient water in the
water container.
^ Check whether the slide control for
the fineness of the coffee is at the
finest setting, or if the amount of
coffee to be ground has been set at
the largest amount.
Because the process is time controlled,
it is possible that the process has taken
so long that there is no time left for
brewing.
^ Select a slightly coarser coffee grind
setting or a lower setting for the
amount of coffee to be ground (see
"Setting the coffee grinder" and
"Settings: customising your machine -
Setting the amount of coffee").
... the machine door will not close.
^ Are the containers in position
correctly?
^ It might be necessary to adjust the
door hinges (see "Installation:
Adjusting the door hinges").
65