To Run The Descaling Programme - Miele CVA 2660 Operating Instructions Manual

To run the descaling programme

DESCALE
K 1 2
^ Turn the left-hand dial to highlight the "Descaling" symbol.
Confirm to start
^ Press the right-hand dial to start the descaling programme.
The right-hand display will guide you through the whole
procedure. Follow the instructions given,
e. g. to empty the drip tray, fill the water container etc.
The descaling programme cannot be stopped once the
right hand control dial has been pressed. The programme
has to be completed through to the end. This is a safety
measure to ensure that the machine is fully descaled, and
is important to protect the machine and ensure it functions
correctly.
^ When a message appears in the right hand display asking
you
– to add descaling agent to the water container please
take the water container out and fill it the the k mark with
lukewarm water. (Do not use less water than this in the
water container because this would cause the descaling
programme to finish early and incorrectly.)
Put 2 descaling tablets in the water. Allow the tablets to
dissolve fully before shutting the lid and putting the water
container back in the machine.
– to use the waste container to collect the waste water, take
it out of the machine and place it under the spout and the
steam valve.
– to take the capsule plate out and replace it with the
coloured descaling funnel: open the front of the machine
and pull the capsule plate all the way out; clean it as
described in Cleaning and care.
Descaling the machine
3 4 5 L o n G C
k
65