If in installation in these applications. Please doubt, consult a qualified technician. contact the Miele Technical Service Department with specific requirements. The appliance must be properly installed before operation to ensure...
Contact Only fill the water tank with cold, Miele. fresh tap water. Warm or hot water Always attach the cord to the or any other liquids may damage the appliance first, then plug it into the machine.
The water lines must be rinsed and Only use the descaling tablets the machine cleaned thoroughly provided by Miele and be sure to before the first coffee is prepared. See use the correct mixture of water and "Daily coffee system care".
a Left display d Right display b Left jog shuttle e Upper door handle (for installation at countertop height) this jog shuttle to turn the f Lower door handle machine on and off. (for installation at a higher level, it selects a desired e.g.
l Main switch o Capsule carousel m Capsule plate p Carousel tray (replaced with the descaling funnel q Water tank when descaling is performed) r Drip tray with grid n Perforator (grid avoids spilling during transport) (not visible, penetrates capsule to s Waste container assist in the brewing process)
COSI LANGUAGE 2 3 4 5 K n I – – selects coffee or espresso Up to 5 different coffee types K, as – shows current actions, e.g. heating well as, steam L and hot water o – prompts an action, e.g. close the –...
^ Press the left jog shuttle. The appliance must be correctly installed and connected before the Míele first use. Welcome! When turned on for the first time, a welcome screen along with other messages will appear in the right display. The welcome screen will be displayed each time the machine is turned on until 5 drinks (including steam) have been prepared.
RINSE K1 2 3 4 5 L o n ^ Hand wash the coffee capsule plate ^ Turn the left jog shuttle to "Rinse". with hot water and liquid dish soap. ^ Press the right jog shuttle. ^ The water tank can be washed in the dishwasher.
The water tank should be washed and filled with fresh cold tap water before each day of use. Never put hot water or any other liquid except cold water into the water tank. ^ Open the appliance door. ^ Lift the water tank and pull it out. ^ Fill the container with fresh, cold tap water to the "Max."...
Only insert Nespresso coffee capsules in the carousel. Damaged, broken or dented capsules should not be used they may jam in the machine. ^ Pull the carousel tray, a, all the way There are five chambers, each can hold out. four capsules.
^ Take the carousel from the machine Twelve different Nespresso coffee types are available for this coffee system. to see which coffee type is filled in They differentiate in terms of acidity, each chamber. fruitness, bitterness and roast. TYPE ARPEGGIO Therefore the preparing times will vary.
^ Turn the right jog shuttle to the first letter or number and press to CHAMBER 5 confirm. The selected letter shows in ARPEGGIO the upper line. ^ Repeat until the desired name is ^ Turn the right jog shuttle to the entered.
If the "Automatic rinsing" option is set to Rinse the water lines before "on" (default setting) the next message preparing the first drink of the day. If shows: the "Automatic rinsing" option is set to "on" and the machine is still cold Rinsing in progress - please wait this will take place automatically.
Prewarming the cups allows the coffee HOT WATER to fully develop the flavor and aroma. K1 2 3 4 5 Use caution. Steam and hot water ^ Turn the left jog shuttle to the "Hot are very hot. water" option. ^ Place a cup under the steam / hot ^ Press the right jog shuttle and half fill water valve.
^ Press the right jog shuttle to interrupt The flavor of the coffee depends on the coffee capsule and the quantity of the coffee dispensing immediately. water used. To ensure the machine uses exactly the amount of water to suit your taste and your cup size, there is a For coffee / espresso recipes see choice of four serving sizes for...
A cappuccinatore (milk froth mug) is supplied with the appliance. Before using the cappuccinatore for the first time, wash it either in the dishwasher or with hot water and The steam is regulated by turning the liquid dish soap. valve: See "Common coffee system care".
The steam supply is temporary. If the ^ Prewarm the cup before filling with steam stops and there is not enough froth. froth prepared, push the steam lever ^ Fill the cappuccinatore to the up then down again. "max" mark with cold milk. ^ Turn the spout to the cup symbol.
^ Fill the cappuccinatore to the For a quick cleaning between froths the "max" mark with cold milk. cappuccinatore lid can be rinsed with the steam valve. ^ Turn the spout to the cappuccinatore symbol. The rinsing replace the ^ Turn the valve over the handle to the cleaning of the cappuccinatore in a froth symbol.
^ Place a cup under the hot water / steam valve. HOT WATER K1 2 3 4 5 ^ Turn the left jog shuttle to "Hot water". ^ Press the right jog shuttle to confirm. ^ Press again to stop the water from dispensing.
The flavor of the coffee depends on the coffee type and the quantity of water Have the correct cups handy. used. To ensure the machine uses ^ Place the desired cup under the exactly the amount of water to suit your coffee dispenser.
^ Turn the right jog shuttle to the first Up to four different user profiles can be programmed to accommodate different letter or number and press to preferences and serving sizes. See confirm. The selected letter shows in "Setting serving sizes". the upper line.
In addition to the default, different If a user profile was set, select the serving sizes can be programmed for profile first before preparing a drink. four additional users. PROFILE PROFILE K1 2 3 4 5 K1 2 3 4 5 ^ Turn the left jog shuttle to "Profile".
The coffee system can be customized to suit individual preferences. SETTINGS F K1 2 3 4 5 ^ Turn the left jog shuttle to "Settings". LANGUAGE K n I The language symbol is selected in the right display. ^ Press the right jog shuttle to select the language option.
TIME OF DAY SETTINGS F : 00 K1 2 3 4 5 ^ Turn the right jog shuttle to select the ^ Turn the left jog shuttle to "Settings". hours, press to confirm. LANGUAGE TIME OF DAY K n I The language symbol is highlighted in ^ Turn the right jog shuttle to select the the right display.
The setting will be automatically saved and the display will go back to the To conserve energy the coffee system previous screen. The coffee system will can be set to turn off automatically after turn off at the preset time. a programmed time interval.
The setting will be automatically saved and the display will go back to the A specific time can be set to turn the previous screen. The coffee system will machine on, e.g. for breakfast. In order turn on at the preset time. to use this function the clock has to be set.
The setting will be automatically saved and the display will go back to the A specific time can be set to turn the previous screen. The coffee system will coffee system off. In order to use this turn off at the preset time. function the clock has to be set.
^ Turning the right jog shuttle clockwise increases the bar size and brightens the settings. SETTINGS F ^ Press the right jog shuttle to save the K1 2 3 4 5 settings. The display shows the previous screen. ^ Turn the left jog shuttle to "Settings". The "back"...
AUTOMATIC RINSING The rinsing feature flushes out coffee residue and pre-warms the coffee on B system. When "Automatic rinsing - on" ^ Turn the right jog shuttle to select "on" is selected the system will automatically be rinsed when the appliance is turned or "off", press to confirm.
STEAM SYSTEM To conserve energy, the steam system can be turned off if steam is not used on B all the time. ^ Turn the right jog shuttle to select "on" Residual heat may allow the or "off". machine to dispense some steam A check marks the current setting.
If the option "Info" is selected, the This option allows you to reset all saved display will show the number of cups of settings to the factory default. coffee dispensed to date (espresso, SETTINGS F coffee, double espresso / coffee). K1 2 3 4 5 SETTINGS F ^ Turn the left jog shuttle to "Settings".
The coffee system can be locked so that it cannot be used by children or ^ Turn the coffee system off by those not familiar with the operating pressing the left jog shuttle. instructions. SYSTEM LOCK ^ Turn the right jog shuttle until the display shows "System lock".
The following components of the coffee Turn the machine off at the main system should be cleaned after each switch before cleaning. day of use to prevent mold and bacteria growth. Allow the coffee system to cool before cleaning. Danger of burns! –...
^ Clean all interior parts and areas of ^ Clean and dry the metal contacts at the machine with a solution of hot the back of the drip tray. If the water and liquid dish soap. See contacts are soiled or wet the unit below for more details.
The cleaning tablets can be purchased from Miele. ^ Press the steam lever down and pull off the rubber sleeve. ^ Clean the rubber sleeve and the steam valve tip with a mild solution of water and liquid dish soap.
The front of the appliance can be Clean the cappuccinatore after every cleaned with a sponge and a solution of use, otherwise it may become blocked warm water and non abrasive liquid with dried milk and hard to clean. dish soap. Dry with a soft cloth. Only use a slightly damp sponge when cleaning the controls.
The perforator should be changed after 15000 cups of coffee / espresso. The perforator can be purchased from Miele. It is recommended to contact the Miele Service department for assistance in performing this maintenance task. SETTINGS F ^ Reassemble the lid as shown in the K1 2 3 4 5 graphics.
The right display goes dark and the appliance is now lowering the perforator. Remove capsule plate and change the capsule hopper ^ Open the appliance door. ^ Pull out the capsule plate. Do not reach up into the ^ Screw the new perforator firmly into perforator opening.
The descaling the best results possible. tablets can be purchased from your local Miele dealer or Miele. Other agents may damage the machine and affect the taste of coffee and hot water.
The right display will prompt you At the beginning of the descaling through the single steps of the program there will be a delayed start to descaling process. allow the tablets to completely dissolve. If the machine has not sufficiently See "Descaling prompts"...
For clarification regarding the prompts see the following: ^ Remove the water tank. ^ Since the machine is also rinsed inside, the drip tray needs to be ^ Fill the water tank with cold tap water emptied to continue. to the k mark. If not filled to the ^ Also empty the waste container at mark, descaling will be prematurely canceled.
If an error occurs a fault message will appear in the right display. Minor problems can be fixed without a service call. Chamber empty - The selected coffee chamber is empty. Fill with coffee capsules. please refill Please fill with fresh water This is a reminder to fill the water tank with fresh water when the machine is turned on.
The unit has no power. – Is the main switch turned off? – Is the machine plugged in? – Check that the fuse is not defective. If so contact the Miele Service Department. – Is the machine plugged in? – Plug the machine in.
The light turns off automatically when the machine has not been used for 10 minutes. The steam lever is not pushed up all the Press the lever down and then up again way. all the way. If the machine was unplugged or a Reset the time of day.
Take out the water tank and then insert it again. ^ Open the appliance door. A coffee capsule is jammed in the carousel. ^ Pull the carousel tray out, lift out the capsule carousel and make sure all capsules can move easily. ^ Insert the carousel in the tray and push it all the way in.
Steam can be dispensed as long as the Once cooled the system will no longer steam heating system is warm. dispense steam. The rubber odor will wear off with time and usage. – Is the spout turned to the side so that –...
The capsule plate is soiled. Clean the capsule plate. – If the maximum water amount is reached, the water dispensing stops automatically. The maximum water amount is saved. – There was not enough water in the – Refill the water tank and reset the tank.
The descaling process cannot be interrupted once the right jog shuttle is pressed. The process now needs to be completed as a safety measure. Descaling is important to increase the life of the machine and to ensure the best results possible. The machine needs to be descaled.
^ Remove, empty and return the waste unit. ^ If the message still shows, open the appliance door and follow the prompts in the right display. See "Removing a jammed capsule from the capsule plate". Call the Miele Technical Service Department.
,Turn the machine off at the main switch in the upper left corner. Danger of electric shock. The machine must be turned off before performing the next steps. ^ Take the carousel and the capsule plate out. ^ Open the appliance door. ^ Turn the machine off at the main ^ On the right side of the capsule plate switch.
In the event of a fault which you cannot correct yourself please contact the Miele Technical Service Department. 1-800-999-1360 firstname.lastname@example.org 1-800-565-6435 email@example.com When contacting the Technical Service Department, please quote the model and serial number of your appliance given on the data plate inside the...
If there is any question concerning the electrical connection of this appliance to your power supply, please consult a licensed electrician or call Miele’s Technical Service Department. U 1-800-999-1360 V 1-800-565-6535...
The coffee system is designed to be built into cabinetry.
If the machine is installed in combination with other Miele appliances, it should be installed with a protective base between the appliance and the unit.
A display cabinet is also available from Miele or your local dealer as an installation option. The display cabinet is intended to hold the CVA 2660 and an optional ESS 2060 Storage Drawer or EGW 2060 Cup Warmer.
Make sure power is not supplied to the appliance while installation or maintenance work is performed. Disconnect the power supply to the work area by unplugging the unit, tripping the circuit breaker or removing the fuse. The coffee system must be properly installed before being used.
You will then be prompted to select a language. The appliance must be correctly ^ Turn the right jog shuttle until the installed and connected before the desired language shows in the first use. display. ^ Press the right jog shuttle to confirm. ^ Press the left jog shuttle to turn the machine on.
The hardness of the water used in the coffee system must be determined and Hardness 1 1 (soft) 0 - 3 0 - 130 programmed into the appliance. The Hardness 2 1 (soft) 4 - 7 130 - 250 water hardness will determine how frequently the unit must be descaled to Hardness 3 2 (medium) 7 - 14...
is the Italian term for a standard is a "dark" espresso. cappuccino with more espresso and less hot milk. is a thin espresso with water added. is a cappuccino without the froth. is espresso with a splash of liquor. is the sign of the perfect cup of espresso - a fine, nut or cinnamon is iced coffee.
is the typical Italian espresso. It is a A very well balanced blend, Livanto is short, strong, full-bodied espresso with characterized by a dense and velvety aroma. It is a uniquely rounded a touch of acidity. It has a pleasantly lingering taste.
is an intense Lungo which combines a beautifully roasted note with a subtle floral note. With its noticeable crema and mild aroma, it is also delicious prepared with milk. Strength: 6 Ideal cup size: Lungo delivers a smooth body and a fine roundness in the mouth.
The cardboard box and packing Old appliances may contain materials materials protect the appliance during that can be recycled. Please contact shipping. They have been designed to your local recycling authority about the be biodegradable and recyclable. possibility of recycling these materials. Please recycle.
Alteration rights reserved / 0905 M.-Nr. 06 541 300 / 00 en / US / CDN CVA 2660...