Adjusting The Interior Fittings; Moving The Shelves; Split Shelf - Miele KFN 9758 iD Operating And Installation Manual

Moving the shelves

The shelves can be adjusted according
to the height of the food.
^ Raise the shelf, and pull it forwards
slightly until the notch at the side is in
line with the shelf support. It can then
be raised or lowered to the required
level.
The raised edge at the back must face
upwards to prevent food from touching
the back of the appliance and freezing
to it.
Stoppers prevent the shelves from
being dislodged by mistake.

Split shelf

In order to accommodate tall items in
the appliance, one of the shelves is
divided. The front section can be
pushed under the rear section.
^ Push the rear half of the glass shelf
up slightly from below.
^ At the same time, pull the front half of
the glass shelf forwards slightly and
then push it carefully under the rear
half.

Adjusting the interior fittings

To move the split shelf:
^ Take both halves of the split glass
shelf out,
^ fit the two brackets onto the supports
on either side at the required height,
^ and push the glass shelves in one
after the other. The shelf with the
raised edge must be at the back.
PerfectFresh zone
compartments
The compartments in the PerfectFresh
zone are on telescopic rails, and can
be removed for filling, emptying or
cleaning purposes.
^ Pull out the compartment as far as it
will go, and then lift it up and out.
Push the runners back in again to
avoid injury or damage.
29