Miele T 586 C Operating Instructions Manual page 22

Problem solving guide
To open the door in the event of
power failure
Water droplets appear at the upper
edge of the drum aperture
A double filter system with dual insula-
tion prevents fluff from being deposited
in the condenser unit.
This means that the condenser unit
does not need to be cleaned so often.
The dual insulation can lead to the
build-up of condensate. Laundry
being removed from the machine may
come into contact with these water dro-
plets. They will, however, dry off in a
matter of minutes.
22
The drum door opens during the
drying cycle.
The machine has overheated. The tem-
perature limiter opens the drum door
and thus causes the machine to switch
off automatically.
Possible reasons for overheating:
The fluff filters in the door and in the
door opening are clogged up.
The condenser unit is blocked.
Before restarting the programme, pro-
ceed as follows:
Release the On-Off button
Clean the affected part of the ma-
chine
Switch the machine on again
Press the "Start" touch pad
Should the drum door open again, this
must be due to a technical fault and
the Service Dept. should be contacted.
Three horizontal lines appear in the
Time display "---".
This may be because the machine has
been on for too long, and a safety cut-
out has operated.
Start the programme again.
If the lines appear again, this indicates
a fault. Call the Miele Service Dept.