Programme Selection - Miele T 586 C Operating Instructions Manual

Programme selection

How the tumble dryer works
This tumble dryer is fitted with an elec-
tronic sensor system. The required de-
gree of dryness is measured and moni-
tored electronically so that the heating
element is switched off as soon as it is
reached. The drying cycle automati-
cally finishes with a cool-ling down
period. This may be follow- ed by the
anti-crease action cycle.
The following three programme groups
are available:
- COTTONS
six programmes from "Extra dry" to "Ma-
chine iron"
- MINIMUM IRON
three programmes from "Normal +" to
"Hand iron"
- TIMED DRYING
timed drying for up to a maximum of
two hours, warm air or cool air.
The following additional information is
available:
SEQUENCE
The programme sequence indicator
shows the current stage of the programme
and the degree of drying reached.
Display field "TIME" (h mins)
The display field is situated to the right
of the sequence indicator and has a
double function:
– Time left (only for timed drying pro-
gramme)
– Delay start
10
Time left
The length of the programme in hours
and minutes appears and the "time left"
indicator light comes on (after the delay
start period has expired, if selected) as
soon as
a timed programme is chosen
the cooling down phase of the COT-
TONS or MINIMUM IRON pro-
gramme is reached.
The length of a timed drying pro-
gramme can be selected using the
_ touch pads between 15 minutes
and 2 hours.
Once the programme has started the
time left counts down at 1 minute intervals.
Delay start
A programme start time can be de-
layed by a maximum of 9 hours 30
minutes.
Select the required programme.
Press the DELAY START touch con-
trol pad.
The indicator light
the pad light up.
Set the delay start by pressing the
$ or > touch pads underneath the
time display:
1 x press = 30 mins
2 x press = 1 hour
Press the START touch pad.
The delay start time is displayed and
counts down in minutes.
Delay start can still be changed after
the START pad has been pressed, (pro-
vided that the Child Safety option has
not been programmed in).
and the one in