Table of Contents
Advertisement
Levelling the tumble dryer
The appliance must be perfectly level to
ensure safe and proper operation.
^ The screw feet can be adjusted to
compensate for any unevenness in
the floor.
,
The air inlet and outlet vents on
the front of the tumble dryer must not
be covered as this would prevent
sufficient ventilation for cooling the
condenser unit.
Room in which the dryer is located
Air taken in for use in the drying
process will be warm when it is
expelled from the front of the dryer. This
expelled air heats up the air in the
room. It is therefore very important to
ensure that the room is adequately
ventilated, particularly if the dryer is
located in a small room. Otherwise
running times and energy consumption
could be increased.
Washer-dryer stack
The tumble dryer can also be
combined with a Miele washing
machine in a washer-dryer stack. The
appropriate "WTV" stacking kit
(available to order) to match your dryer
is required.
,
Stacking kits must only be
installed by a suitably qualified fitter.
Before moving the tumble dryer
again (e.g. when moving house)
After each use a small quantity of
condensed water will collect in the area
around the pump. This water can run
out if the tumble dryer is tipped up
when it is being moved. It is a good
idea to run the Cool air programme for
approximately 1 minute before moving
the tumble dryer. Any remaining
condensed water will then be fed into
the condensed water container or out
through the drain hose.
Installation
31
Hide quick links:
Advertisement
Table of Contents
