Check And Fault Messages - Miele T 294 C Operating Instructions Manual

Problem solving guide

Check and fault messages

Problem
The Empty out
container indicator
lamp comes on.
The programme stops
and the Machine iron
or Hand iron indicator
lamp flashes.
The buzzer sounds.
The Finish/
Anti-crease indicator
lamp flashes while
drying is in progress.
The programme stops
and the Finish/
Anti-crease indicator
lamp comes on.
The buzzer sounds.
The Cool air indicator
lamp comes on and a
continuous alarm
sounds.
26
Possible cause
The condensed water
container is full or there is
kink in the drain hose.
No obvious cause.
The programme selector
was moved after the start of
a programme. The
programme continues to
run as normal.
This is not a fault.
The electronic unit has
recognised that there is no
laundry in the drum and
cancelled the programme.
Drying individual garments
or items which are already
dry can also cause the
programme to be
cancelled.
The dryer is not working
efficiently or economically.
Remedy
– Empty out the
condensed water
container.
– Check the drain hose.
– The indicator lamp will
go out if you switch the
dryer off and then back
on again.
– Switch the dryer off and
then on again.
– Then start the
programme again.
If the programme stops
again and the indicator
lamp flashes again there is
a fault. Contact the Miele
Service Department.
Turn the selector back to
the original position and
the indicator lamp will go
out.
Use the Warm air
programme (timed drying)
to dry individual items.
Before changing a
programme: Open and
close the door.
See the previous page
under "Drying is taking
too long ...".