Replacing The Condenser Unit - Miele T 294 C Operating Instructions Manual

Cleaning and care
^ Then flush the unit through from the
front.
^ Check the condenser unit again for
any visible fluff and if necessary flush
it through again until it has all gone.
^ Remove any soiling still visible inside
the housing unit by hand using a
damp cloth. Do not try and access
areas you cannot reach by hand!
^ Also make sure the rubber seals are
clean.
The rubber seals must not be
removed and must be free of kinks.
22

Replacing the condenser unit

^ With the handle facing upwards, push
the condenser unit back into position
in its housing.
^ Turn the lever down to the horizontal
position, making sure that the hook
on the lever clicks into the groove.
When replacing the inner cover after
cleaning, ensure that the rubber seal
fits correctly into the groove.
^ Replace the inner cover making sure
the hooks locate correctly. Hold it at
an angle and push it gently
downwards.
^ Then turn the lever upwards into the
horizontal position to lock the cover.
^ Replace the service panel and press
the upper edge until it clicks into
position.
,
It is important to ensure that both
the condenser unit and the cover are
correctly positioned and locked
otherwise water may leak from the
dryer.