Advertisement
^ Push the appliance into its housing
unit.
When doing this, make sure that the
mains cable does not get trapped.
^ Depending on the thickness of the
appliance housing walls, push the
appliance into the niche until
– the spacer piece touches the
housing unit wall a (16 mm thick
walls), – or the front edges of the
hinges are flush with the side walls of
the housing unit b (19 mm thick
walls).
The cover strip must
front of the edge of the housing unit.
It must disappear completely into
the niche.
^ Push the hinged side of the
^ Align the appliance by altering the
^ Secure plastic bracket c to the side
^ Push the appliance in until the plastic
^ To fix the appliance to the housing
protrude in
appliance to the furniture wall.
adjustable feet using the spanner
supplied f.
opposite the hinges using the M5 x
22 countersunk screws d.
bracket is flush with the front edge of
the housing unit floor e.
unit at the top and bottom, screw the
long 4 x 19 mm chip board screws a
loosely into the hinge.
33
Advertisement
