Table of Contents
Advertisement
Operation
Starting a programme
^ Select the
Start
Please close the door
The message
will appear.
If you want to select a different
programme or make other changes,
Back
select
and cancel the programme
Cancel
with the
function.
^ Start the programme by closing the
door.
The In-operation indicator light comes
on to show that a programme has been
started.
If you open the door
appear in the display.
As long as this prompt is showing,
crockery can be added without
compromising the wash results.
A programme can only be cancelled
in the first few minutes. Otherwise
the programme must continue to the
end so that important programme
stages (e.g. reactivating the water
softener) are not omitted.
38
option.
Add-an-item
will
Time display
The duration of the programme
selected appears in hours and minutes
in the Time display before the
programme begins. During the
programme, the time left until the end of
the programme is displayed.
The time displayed may vary with the
same programme. This could be due to
the water temperature at each intake,
the reactivation cycle, the amount of
crockery and how dirty it is.
When a programme is selected for the
first time, the display shows an average
time for a cold water intake.
The times shown in the Programme
chart refer to standard test loads and
temperatures.
Each time a programme is run, the
electronic unit adjusts the programme
duration according to the amount of
crockery and the temperature of the
incoming water.
To save energy, the time display
goes out after a few minutes if you do
not touch any buttons during this
time. Press any button (apart from the
Off button V) to switch the time
display back on again.
Hide quick links:
Advertisement
Table of Contents
