Table of Contents
Advertisement
5
Start the server.
6
At the NetWare server console prompt, type load
nwconfig.nlm and press Enter.
7
Select Driver Options and press Enter.
8
Select Configure disk and storage device drivers and press Enter.
Select Select an additional driver and press Enter.
9
10 Insert the driver disk, then press the Insert key.
All available drivers are displayed.
11 Press the Insert key again to access additional drivers.
12 Press Enter to scan for the drivers.
13 Select ICP Advanced RAID Controller and press Enter.
The aacraid parameters screen is displayed.
14 Select Select/Modify driver Parameters and press Enter.
15 Select Save parameters and load driver.
16 When prompted to select an additional driver, select No.
17 Press Esc to exit the
18 Create arrays using the ICP RAID Configuration utility (see
Using the ACU on page
Manager (refer the online Help). Alternatively, you can create
arrays using the ARCCONF Command Line program. ( see
Appendix D, Installing and Using the Command Line
Now that you have installed the drivers, refer to your NetWare
documentation to modify disk partitions, apply hot fixes, or
perform volume maintenance. See also
During Server
Restart.
Loading NetWare Drivers During Server Restart
To automatically load the
the
file (usually located in your server's startup
startup.ncf
directory) must contain a load command line that specifies the
location of the driver and any appropriate command line options.
utility.
Nwconfig
A-2) or remotely using ICP Storage
driver during server restart,
aacraid.ham
Installing the Driver
Loading NetWare Drivers
Utility).
3-11
Advertisement
Table of Contents
