Table of Contents
Advertisement
UnixWare and OpenUNIX
This section contains the following procedures:
Installing the Driver When You Install UnixWare or OpenUNIX
Installing the Driver in an Existing UnixWare or OpenUNIX System
Note: Although the driver disk you create for UnixWare and
OpenUNIX differ, the installation procedures for these
operating systems are the same.
Installing the Driver When You Install UnixWare or OpenUNIX
To install the driver when installing UnixWare or OpenUNIX:
1 Install and configure the controller and hard disk drives, as
described on
2 Create the bootable array, as described on
3 Create the driver disk, as described on
remove the driver disk.
4 Insert the Unix installation CD and start the operating system
installation.
5 When you see the prompt, insert the driver disk, select Install
HBA diskette, and then press F10.
The computer loads the driver from the driver disk and
displays the HBA screen.
6 Select Proceed with Installation, then press F10.
7 Complete the installation as appropriate.
8 When the installation is finished, remove the driver disk and
restart the computer.
Installing the Driver in an Existing UnixWare or OpenUNIX System
To install the driver in an existing UnixWare or OpenUNIX system:
1 Shut down the computer. Install and configure the controller
and hard disk drives, as described in
2 Create the driver disk, as described on
remove the driver disk.
3 Turn on the computer, then insert the driver disk.
page
2-2.
Installing the Driver
page
2-4.
page
3-2. When finished,
Chapter
2.
page
3-2. When finished,
3-8
Advertisement
Table of Contents
