Additional Functions; Factory Default Setting - Miele G 1142 Operating Instructions Manual

Factory default setting

If you have altered any settings from
the factory default, you can re-set them
back to the factory default settings as
follows:
^ Switch the dishwasher off with the
On/Off button K.
^ Press the Start/Stop button in and
whilst holding it in switch the
dishwasher on using the On/Off
button K.
Keep the Start/Stop button pressed in
until the "Start/Stop" indicator light
comes on.
If this does not happen, start the
procedure from the beginning again.
^ Press the programme selector button
12 times.
The lowest programme indicator will
give one long flash and two brief
flashes at intervals.

Additional functions

The Wash/Rinse indicator light shows
whether a setting other than the factory
default setting has been set.
– If the Wash/Rinse indicator light is
flashing:
All settings are factory default
settings.
– If the Wash/Rinse indicator light is
not lit up:
At least one setting has been altered
from the factory default setting.
^ To reset the dishwasher to the factory
default settings, press the Start/Stop
button.
^ Switch the dishwasher off with the
On/Off button K.
37