Setting The Rinse Aid Dosage - Miele G 1021 Operating Instructions Manual

Before using for the first time

Setting the rinse aid dosage

You can adjust the rinse aid dosage for
best results.
The rinse aid dosage can be set from
approx. 0-6 ml. It is set to a
recommended setting of approx. 3 ml
at the factory.
If spots appear on crockery and
glassware:
^ Increase the rinse aid dosage.
If clouding or smearing appears on
crockery and glassware:
^ Decrease the rinse aid dosage.
^ Switch the dishwasher off using the
K button.
^ Turn the programme selector to the
"12 o'clock" position.
^ Press the Start/Stop button J / M in,
and whilst holding it in switch the
dishwasher on using the K button.
Keep the J / M button pressed in
until the J / M indicator light comes
on.
If this does not happen, start the
procedure from the beginning again.
22
^ Turn the programme selector to the
"5 o'clock" position.
The programme sequence indicator
will flash briefly three times at intervals.
This means that approx. 3 ml of rinse
aid will be used per programme
(factory default setting).
The number of times the
sequence indicator flashes tells you the
rinse aid dosage which has been set
(see chart).
Rinse aid
in ml
0
1
2
3
4
5
6
^ Use the J / M button to select the
number of flashes which equates to
the rinse aid dosage you want.
Each press of the button moves you
up a level.
The programmed rinse aid dosage is
now stored in memory.
^ Switch the dishwasher off using the
K button.
programme
Flash frequency
-
Once
Twice
Three times
Four times
Five times
Six times