Check And Fault Indicator Lamps - Miele T 253 C Operating Instructions Manual

Anti-crease /
Finish
Locked
The inner cover of the
condenser unit has not
been locked properly
and/or the condenser unit
has not been positioned
correctly.
Fluff has collected at the
bottom of the condenser
unit housing.
The lighting switched off
automatically.
The lamp needs changing. Change the lamp as
The lighting switched off
automatically.
The programme selector
was moved after the start
of a programme. The
programme continues to
run as normal.
The system lock is
activated.
– Ensure that the condenser
unit is positioned correctly
lock the cover.
– Check the rubber seals.
– Use a cloth to remove any
fluff from the inside of the
condenser unit housing.
The lighting only comes on
when the door is opened if
the dryer is switched on. To
save energy the lighting
goes out after a while if the
door is left open.
described at the end of this
section.
It lights up when drying is in
progress and goes out
shortly after the end of the
programme to save energy.
Turn the selector back to the
original position and the
indicator lamp will go out.
If you wish to use the dryer,
the system lock must be
deactivated (see "Electronic
system lock").
29