Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Miele DA 422-4
Summary of Contents for Miele DA 422-4
- Page 1 Operating and installation instructions Cooker hood DA 422-4, DA 422-4 EXT en - GB To avoid the risk of accidents or damage to this appliance, it is essential to read these instructions before it is installed and used for the first time.
-
Page 2: Table Of Contents
Contents Caring for the environment ......... . 3 Warning and Safety instructions . -
Page 3: Caring For The Environment
Caring for the environment Disposal of the packing material Disposal of your old appliance The transport and protective packing Electrical and electronic appliances has been selected from materials which often contain materials which, if are environmentally friendly for handled or disposed of incorrectly, disposal, and should be recycled. -
Page 4: Warning And Safety Instructions
Any other usage is not supported by This appliance complies with all the manufacturer and could be relevant legal safety requirements. dangerous. Miele cannot be held liable Inappropriate use can, however, for damage resulting from incorrect or lead to personal injury and damage improper use or operation of the to property. -
Page 5: Technical Safety
Technical safety Installation, maintenance and repairs may only be carried out by a Before installation, check the cooker Miele authorised person in accordance hood for visible signs of damage. with current national and local safety Under no circumstances should you regulations. - Page 6 These models may only be combined with a Miele external motor. This appliance must not be used in a non-stationary location (e.g. on a ship).
- Page 7 Warning and Safety instructions In order to ensure safe operation, and to prevent gases given off by the heating appliances from being drawn back into the room when the cooker hood and the heater are in operation simultaneously, an underpressure of 0.04 mbar (4 pa) is the maximum permissible in the room.
-
Page 8: Correct Use
Warning and Safety instructions Correct use Do not use the cooker hood without the filters in place. This way you will Never use an open flame beneath avoid the risk of grease and dirt getting the cooker hood. To avoid the danger into the appliance and hindering its of fire, do not flambé... - Page 9 Safety regulations prohibit the fitting of a cooker hood over solid fuel stoves. All ducting, pipework and fittings must be of non-flammable material. These can be obtained from the Miele Spare Parts department or from builders' merchants. The appliance must not be connected to a chimney or vent flue which is in use.
-
Page 10: Guide To The Appliance
Guide to the appliance... - Page 11 Guide to the appliance Telescopic extension piece Tower Canopy Control panel Grease filters Hob lighting Touch control for hob lighting This control switches the lighting on and off, and is also a dimmer switch. On/Off touch control for the fan Touch controls to select the fan power level Touch control for the run-on...
-
Page 12: Modes Of Operation
Modes of operation The cooker hood works with . . . air extraction: . . . an external motor: (...EXT models only) The air is drawn in and cleaned by the grease filters and directed outside. The ...EXT models are designed to be If the on-site ventilation system does connected to an external motor located not have a non-return flap, the... -
Page 13: Operation
Operation To switch the fan on Automatic switch-off of the Intensive setting You can set the Intensive setting so that it only runs for 10 minutes before reverting automatically to level III. ^ Press the On/Off control. ^ To set this option, both the fan and The fan runs at power level "II". -
Page 14: Run-On Option
Operation Run-on option It is advisable to leave the fan running for a few minutes after cooking has finished to neutralise any lingering The indicator lamps for fan power levels odours in the air. I and IV will flash if the automatic The fan can be set to switch off switch-off for the Intensive setting is not automatically after either 5 or 15... -
Page 15: To Switch The Hob Lighting On
Operation To switch the hob lighting on Safety cut-out The hob lighting can be switched on Should the cooker hood be left on, the and off independently of the fan. fan will switch off automatically after 10 hours. The lighting will remain on. ^ Briefly press the hob lighting control to switch on the hob lighting. -
Page 16: Filter Operating Hours Counter
Operation Filter operating hours counter Reading the filter operating hours counter The number of hours the appliance has been in operation is stored in memory. To check the percentage of time set already used: The operating hours counter tells you when the grease filters need to be cleaned. - Page 17 Operation Altering the filter operating hours counter The filter operating hours counter is set at 30 hours. This can be lengthened or The – / + indicator lamps show the time shortened to suit the type of cooking which has been set: you do.
-
Page 18: Cleaning And Care
Cleaning and care A range of Miele branded cleaning and Do not use too much water when conditioning agents are available to cleaning the controls. Water could order through your Miele Dealer / Chartered Agent, the Miele Spare Parts penetrate into the electronics and Department, or via the internet on cause damage. -
Page 19: Grease Filters
Cleaning and care Grease filters Important for appliances with lacquered housing The re-usable metal grease filters in the appliance remove solid particles (special order finish) (grease, dust, etc.) from the kitchen It is very difficult to clean this type of vapours, preventing soiling of the surface without causing minor marks to cooker hood. - Page 20 ^ Do not wash at more than 65° C. If a approximately 3 seconds to reset the Miele dishwasher is being used, operating hours counter. select the Sensor wash programme. The indicator lamp will go out.
-
Page 21: Changing A Halogen Lamp
Cleaning and care Changing a halogen lamp ^ Before any cleaning or maintenance work, disconnect the cooker hood from the mains supply. Exercise caution when changing halogen lamps. They get very hot during use and remain hot for some time after being switched off. Let them cool down before you change them. -
Page 22: Appliance Dimensions
650 mm above gas hobs and cookers. If this cooker hood is installed above a Miele Wok CS 1028 CombiSet appliance, a minimum safety distance of 760 mm must be maintained between the burner and the lower edge of the cooker hood. - Page 23 Appliance dimensions – When deciding on the safety distance between the hob and cooker hood, please note that a distance of 650 mm above electric cookers/hobs may be preferable to give more working space under the hood. – Account should also be taken of the height of the person who will be using the hood most often.
-
Page 24: Installation
Installation Assembly parts... - Page 25 Installation 3 protective sheets for use when fitting the tower. 1 exhaust connection for exhaust 8 screws 5 x 40 mm and ducting C 150 mm. 8 x S 8 plugs for securing the wall bracket. 1 reducing collar for exhaust ducting C 125 mm. The screws and plugs are 1 non-return flap designed for use in solid walls only.
-
Page 26: Installation Instructions
Installation Dismantling Before installation, it is important to Should the appliance ever need to be read the information given on the dismantled, follow the installation following pages as well as the instructions in reverse order as "Appliance dimensions" and the described on the installation sheet. -
Page 27: Electrical Connection
Electrical connection If the switch is not accessible after All electrical work should be installation (depending on country), an undertaken by a suitably qualified additional means of disconnection must and competent person in strict be provided for all poles. accordance with current national For extra safety it is advisable to protect and local safety regulations the appliance with a suitable residual... -
Page 28: Operation With Control Module Dsm 400
Operation with Control module DSM 400 The Miele DSM 400 control module can Components used in the central be used to combine the cooker hood ducting system are not supplied by with other components. Miele. It enables the following: If in any doubt, the advice of a... -
Page 29: Connection For Air Extraction
Connection for air extraction – Only use smooth pipes or flexible Important: To avoid the danger of hoses made from non-flammable toxic fumes, please observe the materials for the extraction ducting. Warning and Safety instructions. – When using an external motor, make This is especially crucial when using sure that the exhaust ducting is the cooker hood at the same time as... -
Page 30: Condensate Trap
Connection for air extraction Condensate trap – If the exhaust air is to be ducted into the open air, the installation of a (optional accessory) telescopic wall vent or roof vent is recommended. – If the exhaust air is to be ducted into a vent flue, the ducting must be directed in the flow direction of the flue. -
Page 31: Silencer
Connection for air extraction Silencer ...with air extraction: (optional accessory) The silencer not only reduces noise from the fan, but also sounds from outside (e.g. traffic noise). For this reason the silencer must be positioned as close as possible to where the ducting leaves the building ...air extraction with external motor: To minimise noise from the motor in the... -
Page 32: After Sales Service
For information on the appliance under guarantee, please contact: guarantee specific to your country – Your Miele Dealer / Chartered Agent please contact Miele. See back cover for contact details. In the U.K. your appliance is –... -
Page 33: Technical Data
Length of connection cable to external DA 422-4....23 kg motor..... . . 1.9 m... - Page 36 Alteration rights reserved / 3011 M.-Nr. 09 201 450 / 00...