Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Miele DA 406
Summary of Contents for Miele DA 406
- Page 1 Operating and installation instructions Cooker hood DA 406 DA 407 DA 409 DA 409 EXT en - GB To avoid the risk of accidents or damage to this appliance it is essential to read these instructions before it is installed and used for the first time.
-
Page 2: Table Of Contents
Miele|home ........ - Page 3 Contents Operation with Control module DSM 400 ......32 Connection to a window contact switch ......32 Potential free connection .
-
Page 4: Caring For The Environment
Caring for the environment Disposal of the packing Disposal of your old appliance material Electrical and electronic appliances often contain materials which, if The transport and protective packing handled or disposed of incorrectly, has been selected from materials which could be potentially hazardous to are environmentally friendly for human health and to the environment. -
Page 5: Warning And Safety Instructions
Warning and Safety instructions This appliance is not intended for This appliance complies with all use by persons (including children) relevant local and national safety with reduced physical, sensory or requirements. Inappropriate use mental capabilities, or lack of can, however, lead to personal injury experience or knowledge, unless they and damage to property. -
Page 6: Technical Safety
Technical safety Installation, maintenance and repairs may only be carried out by a Before installation, check the cooker Miele authorised person in accordance hood for visible signs of damage. with current national and local safety Under no circumstances should you regulations. - Page 7 These models may only be combined with a Miele external motor. This appliance may only be used in mobile installations such as ships, caravans, aircraft etc. if a risk...
- Page 8 The Miele DSM 400 control module as ensuring that the cooker hood can offers the possibility of combining other only be switched on when the heating components with the cooker hood (see appliance is switched off or vice versa.
-
Page 9: Correct Use
Warning and Safety instructions Correct use Do not use the cooker hood without the filters in place. This way you will Never use an open flame beneath avoid the risk of grease and dirt getting the cooker hood. To avoid the danger into the appliance and hindering its of fire, do not flambé... - Page 10 Safety regulations prohibit the fitting of a cooker hood over solid fuel stoves. All ducting, pipework and fittings must be of non-flammable material. These can be obtained from the Miele Spare Parts department or from builders' merchants. The appliance must not be connected to a chimney or vent flue which is in use.
-
Page 11: Modes Of Operation
Modes of operation . . . air recirculation: The cooker hood works with (available as an optional extra with a conversion kit and charcoal filter: see "Technical Data") . . . air extraction: The air is drawn in and cleaned by the The air is drawn in and cleaned first by grease filters and directed outside. -
Page 12: Guide To The Appliance
Guide to the appliance... -
Page 13: Guide To The Appliance
Guide to the appliance Extension piece Touch control for grease filters Tower The indicator lamp for the grease filter touch control lights up when the grease Canopy filters need to be cleaned. Control panel The touch control is used: Grease filters –... -
Page 14: Miele|Home
Miele electric hob with onset controls. This module must be installed by a Miele service technician or suitably For communication to take place, the qualified electrician. -
Page 15: Operation
The indicator lamp will come on. If the cooker hood has been connected to a window contact switch via the Miele Control module ^ Press the run-on option touch control DSM 400 then the fan cannot be for approx. 10 seconds. The first fan switched on if the window is shut. -
Page 16: Run-On Option
Operation Run-on option It is advisable to run the fan for a few minutes after cooking is finished to neutralise any lingering odours in the The indicator lamps for fan power levels air, whether you are using air extraction "I" and "IV" will flash if the automatic or recirculation mode. -
Page 17: Switching The Lighting On
Operation Switching the lighting on Safety cut-out The hob lighting can be switched on Should the cooker hood be left on, the and off independently of the fan. fan will switch off automatically after 10 hours. The lighting will remain on. ^ Briefly press the lighting touch ^ Pressing the On/Off touch control will control to switch on the hob lighting. -
Page 18: Filter Operating Hours Counter
Operation ^ Press the charcoal filter touch control Filter operating hours counter for about 3 seconds. The number of hours the appliance has been in operation is stored in memory. The indicator lamp for the touch control will go out. Reading the filter operating hours counter The indicator lamp for the grease filter... - Page 19 Operation Filter operating hours counter You can set the operating hours counter to suit the type of cooking you The indicator lamp for the grease filter – Select a short time if you roast or fry touch control and one of the "– / +" a lot.
- Page 20 Operation Setting and altering the charcoal filter operating hours counter (with recirculation mode) The charcoal filter is needed for The "– / +" control lamps show the time recirculation mode. which has been set: 1st lamp from the left = 120 hours The cooker hood is set at the factory for 2nd lamp from the left = 180 hours extraction mode.
-
Page 21: Cleaning And Care
(This infomation does not apply to the controls). The surfaces and controls are Stainless steel surfaces can be cleaned susceptible to scratches and using the Miele E-cloth, or with a abrasions. Please observe the proprietary non-abrasive cleaning following cleaning instructions. agent designed specifically for use on stainless steel. -
Page 22: Grease Filters
Cleaning and care Controls The controls may suffer discolouration or damage if soiling is left on them for too long. Remove soiling straight away. Observe the General notes on cleaning earlier in this section. Do not use stainless steel cleaning agents on the controls. - Page 23 3 seconds to re-set the 65°C programme, ensuring the spray operating hours counter. arm is not obstructed. If a Miele The indicator lamp will go out. dishwasher is being used, select the If the grease filters are cleaned before Sensor wash programme.
-
Page 24: Fitting And Replacing The Charcoal Filter
New filters can be purchased from – if it is no longer effective in absorbing your Miele dealer or from the Miele kitchen odours. Spare Parts Department. It should, however, be replaced at least See back cover for contact details, every 6 months. -
Page 25: Changing A Halogen Lamp
Cleaning and care ^ First remove the grease filters from Changing a halogen lamp the cooker hood. Before any cleaning or maintenance work, disconnect the cooker hood from the mains supply. Ensure that – it is switched off at the wall socket and the plug is withdrawn, or –... -
Page 26: Appliance Dimensions
Appliance dimensions DA 406 DA 409 1) Extraction 2) Recirculation 3) Ventilation grille position for recirculation 4) and 5): (5 is not required for recirculation mode cooker hoods) The shaded area represents the wall or ceiling area for the vent cut-out, for fitting the connection socket and on ...EXT models for feeding the... -
Page 27: Safety Distance Between Hob And Cooker Hood (S)
If this cooker hood is installed above of the cooker hood. a Miele Wok CS 1028 CombiSet appliance, a minimum safety distance of 760 mm must be maintained between the burner and the lower edge of the cooker hood. -
Page 28: Installation
Installation Assembly parts... - Page 29 Installation 3 protective sheets for use when fitting the tower. 2 hose clips 2 x M 6 self-tapping nuts for securing the exhaust ducting. for securing the appliance. 1 reducing collar for exhaust ducting C 125 mm. 1 non-return flap 2 screws 3.9 x 7.5 mm for fitting into the exhaust connection for securing the tower.
-
Page 30: Installation Instructions
Installation Dismantling Before installation, it is important to Should the appliance ever need to be read the information given on the dismantled, follow the installation following pages as well as the instructions in reverse order as "Appliance dimensions" and the described on the installation sheet. -
Page 31: Electrical Connection
Electrical connection If the switch is not accessible after All electrical work should be installation (depending on country), an undertaken by a suitably qualified additional means of disconnection must and competent person in strict be provided for all poles. accordance with current national For extra safety it is advisable to protect and local safety regulations the appliance with a suitable residual... -
Page 32: Operation With Control Module Dsm 400
Operation with Control module DSM 400 The Miele DSM 400 Control module can If the control module is disconnected be used to combine the cooker hood in order to operate the cooker hood with other components. without the window contact switch It enables the following: (e.g. -
Page 33: Connection To A Light Switch
Operation with Control module DSM 400 Connection to a light switch The control module can be used to switch on the cooker hood lighting and also to dim it, depending on model, via a light switch in the house. Installation The tower needs to be removed before the control module can be fitted to the fan unit. -
Page 34: Connection For Air Extraction
Connection for air extraction Important: To avoid the danger of If the exhaust ducting is secured to toxic fumes please observe the the exhaust stub by a hose clip, Warning and Safety instructions. ensure that it is fitted correctly. Do This is especially crucial when using not overtighten. -
Page 35: Condensate Trap
Connection for air extraction Important: Cooker hoods designed for use with an external motor (...EXT models) have an If the exhaust ducting is to run through integrated condensate trap. rooms, ceiling space etc. where there may be great variations in temperature Silencer between the different areas, the problem of condensation will need to... -
Page 36: After Sales Service
In the event of a fault which you cannot correct yourself, or if the appliance is under guarantee, please contact: – Your Miele Dealer / Chartered Agent – The Miele Customer Contact Centre (see back cover for address). When contacting your Dealer or Miele, please quote the model and serial number of your appliance. -
Page 37: Technical Data
Level I ....180 m DA 406....22.1 kg Level II. - Page 40 Alteration rights reserved / 4209 M.-Nr. 07 285 740 / 02...