Miele KM 81-2 Operating Instructions Manual page 7

Gas
Hide thumbs Also See for KM 81-2:
Table of Contents

Advertisement

Warning and Safety Instructions
Installation work and repairs may
only be carried out by a suitably
qualified and competent person,e.g.
'Corgi' registered for gas in G.B.
Repairs and other work by unqualified
persons could be dangerous.
The appliance is only completely
isolated from the electrical supply
when it is switched off at the wall
socket, or the mains fuse is withdrawn,
or the screw-out fuse is removed (in
countries where this is applicable). Do
not pull by the mains cable, but by the
plug when withdrawing the plug from
the socket.
Do not connect the appliance to the
mains electrical supply by an exten-
sion lead. Extension leads do not guaran-
tee the required safety of the appliance.
Gas burners should only be used
in rooms with adequate ventilation.
Ensure that the worktop area around
the hob is clear of obstacles to allow
sufficient ventilation.
Warning and Safety Instructions
Important notes for the installer
Check that all parts of the burner
unit are correctly assembled be-
fore igniting the gas, otherwise the igni-
tion could malfunction.
Please note the following, in cases
where the hob is on LPG supply:
Where this appliance is installed in
marine craft or in caravans, it shall not
be used as a space heater.
When installing the gas hob, the
following minimum dimensions
must be kept:
25 cm distance from any heat-sensi-
tive material or surfaces, otherwise
some form of insulation must be
fitted.
65 cm between the hob and a wall
unit above it.
65 cm between the hob and a
cooker hood above it.
Wall sealing strips and any back-
moulding must be of heat resistant
material.
7

Advertisement

Table of Contents
loading

Table of Contents