Table of Contents
Advertisement
Instructions for building-in
Instructions for building-in
Stick the seal provided
edge of the hob. Any sealing strip
still protruding should be cut off with
a sharp knife.
loosen
b
Appliance
c
Tensioning screw
d
Clamp
e
Worktop
f
Seal
Turn the tensioning screws
direction of the arrow until the
clamps on the appliance
swung out.
Place the appliance in position, turn
the clamps and tighten the tension-
ing screws until the clamps hold the
e
worktop
. Do not overtighten.
Connect the appliance to the electri-
cal supply.
When building-in more than one Com-
biset unit, a stainless steel spacer bar
(V 98 ) must be installed between each
unit. It is supplied with its own installa-
tion instructions.
24
f
under the
tighten
c
in the
b
can be
Advertisement
Table of Contents
