Housing; Grease Filter - Miele DA 360 Operating And Installation Manual

^ To take out the grease filter press the
locking clip in towards the middle of
the filter. Holding carefully, lower and
remove the filter. Take care not to let
the filter drop onto the hob below.
Take care not to let the grease filter
fall onto the hob below.
^ Clean the filter
– with a nylon brush, warm
water with a little washing up liquid.
–
with the short side upright in the
lower basket, ensuring the spray arm
is not obstructed.
Note: some dishwasher detergents
may cause the surface of the metal
filter to discolour.
However, this will not affect the
functioning of the grease filter in any
way.
12
place the filter
^ After cleaning leave the filter to dry
for a while on an absorbent surface
before putting them back in place.
^ When removing the filter for cleaning
also clean off any residues of oil or fat
from the now accessible housing to
prevent the risk of these catching fire.
When putting the grease filter back in
position, ensure that the locking clip is
visible facing down towards the hob.
Should the grease filter be put back
upside down:
Insert a small screwdriver into the slits
to disengage it. Do not let it drop on to
the hob below.