Miele WT 946i S wps Operating Instructions Manual page 22

How to wash correctly
J Adding detergent
It is important to dispense the correct
amount, because... . .
. . . too little detergent results in:
– Laundry not being cleaned properly
and with time it may become grey
and hard to the touch.
– Greasy particles clinging to the
laundry.
– Limescale deposits on the heater
elements.
. . . too much detergent results in:
– Excessive foam, which causes a low
level of agitation and poor wash,
rinse and spin results.
– Higher water consumption because
an extra rinse is automatically
activated.
– A burden to the environment.
Add detergent for the pre-wash to
compartment i and to compartment
j for the main wash. If the capacity of
compartment j is not sufficient (e.g.
in water hardness area III), some of the
main wash detergent can be added to
compartment i.
22
^ Pull out the detergent drawer and
place detergent in the compartments
as follows:
i =
Pre-wash
(if selected, 1/4 of the total
amount recommended for the
programme)
j =
Main wash
including the Soak period
if selected
p = Fabric conditioner or
liquid starch.
See "Detergent" section for further
information.