An Unsatisfactory Drying Result - Miele WT 2679 WPM Operating Instructions Manual

An unsatisfactory drying result

Problem
The laundry is still
damp after a drying
cycle.
The laundry is too
damp or too dry
after a drying cycle.
There is still water
in the drum after
drying.
Possible cause
The load was too small
for the electronics to
assess the residual
moisture correctly.
The laundry has formed
a ring in the drum during
the spin because it was
distributed unevenly.
The laundry has formed
a ring in the drum during
the thermospin because
it was too damp or the
spin speed was set too
high.
Warm laundry feels
damp.
The required residual
moisture level is between
two drying levels.
There is a blockage in
the water outlet.
Problem solving guide
Remedy
In future dry small loads in a
timed drying programme.
– Turn the programme selector
to Stop.
– Open the door and loosen
the laundry.
– Start the drying programme
again using a lower spin
speed.
Extend the cool down time, as
described in "Settings menu J",
"Set extended cool-down".
Either extend or shorten the
drying times, as described in
"Settings menu J", "Alter time".
Clean the drain filter and the
drain pump as described in
"Problem solving guide –
Opening the drum door in the
event of a blocked drain outlet
and/or power failure".
55