Connection To Services; Gas Connection - Miele KM 417 Operating Instructions Manual

Connection to services

Important
This appliance should be installed
with plenty of space on either side.
See Installation Instruction Booklet
before making the gas and electrical
connection.

Gas connection

Connection to the appropriate gas
supply, or conversion from one type
of gas to another should be carried
out in strict accordance with local
and national safety regulations by an
approved and registered gas
installer (e.g. Corgi registered in the
U.K.) who is responsible for the
correct functioning of the appliance
when installed.
Check with your local gas supplier
about the type of gas and its
calorific value and compare this
information with the type of gas
quoted on the hob data plate.
The gas installation must be made in
such a way that the isolating valve is
visible and easily accessible after
the appliance has been built in.
Corgi regulations state that a
pressure test nipple must be
installed near a gas hob to allow an
engineer to test the pressure
following servicing.
20
This gas hob is normally suitable for
connection to either natural or liquid
gas. Check suitability in your country
with your dealer or agent.
Category EN 30:
United Kingdom:
GB II 2 H 3 + 20 mbar, 28-30/37 mbar.
Ireland:
IE II 2 H 3 + 20 mbar, 28-30/37 mbar.
Depending on country, a set of jets for
conversion to liquid gas is included
with the hob.
Conversion to another type of gas is
described in the separate Installation
Instructions supplied with this hob.