Time & Day Setting; Filter Life Reset (New Filter) - IQAir HealthPro Compact User Manual

Chapter 4 – Using the Control Panel
4.4.7 Time & Day Setting
When the IQAir system is first connected to the power, the day and time displayed
will be incorrect and will have to be set for the timer function to work properly.
Once the current day and time are set, they will only need to be reset if the system
is disconnected from the power supply for more than an hour.
1. To access the Time & Day menu from the main display window, press the Menu
key six times.
2. Press and hold the Enter key until the cursor starts to flash.
3. Select the hour by pressing the
4. Press the Enter key to save the hour setting and to proceed to the minute setting.
5. Select the minutes by pressing the
6. Press the Enter key to save the minute setting and to proceed to the day
setting.
7. Select the day of the week by pressing the
8. Press the Enter key to save the day setting and to exit the enter mode.
9. Press the Power key to return to the main display. Note: The display will
automatically return to the main window if no key is pressed for 15 seconds.

4.4.8 Filter Life Reset (New Filter)

The Filter Life Reset function allows the Filter Life Monitor to be reset after a new
filter has been inserted. As a result, the appropriate filter life LED on the control
panel will be reset to green and the hour count in the Filter Life Monitor menu
will be reset to the full life span of the new filter. Note: Resetting the Filter Life
Monitor will also cancel the "Replace Filter" warning from the main display
window.
1. To reach the Filter Life Reset function from the main display window, press
the Menu key seven times.
2. Press and hold the Enter key until the flashing cursor appears. Release the
Enter key. The first filter selection to appear is the pre-filter.
3. Press the key to select the filter that has been replaced.
The filter life LED for the appropriate filter is now flashing red.
4. Press the Enter key to confirm that the selected filter has been replaced.
5. Press the Enter key one more time to confirm the filter change.
Or to exit, press the Menu key (M-Menu).
6. Upon successful reset of the filter life, the new remaining filter life (taking the
currently selected fan speed into account) will be displayed, and the filter LED
light on the control panel will change from red to green.
18
key.
key.
key.