Overview; General Safety - Titan TPW-2200 Owner's Manual

GENERAL SAFETY

The following safety precautions must be observed at all
times because the pressure washer and components make
up a high pressure system.
A. Follow all codes for the safe operation of this equipment
both local and federal (United States Occupational Safety
and Health OSHA)
B. Only people that are well acquainted with the rules of safe
operation should use the unit.
C. Read and understand all manuals and instructions in-
cluded with the pressure washer before attempting to use
it.
D. KEEP CHILDREN AWAY FROM THE UNIT.
E. Wear safety glasses while operating the unit.
F. Do not stand on the unit or attempt to use it as a hand
hold.
G. Do not make adjustments to washer while engine is run-
ning
1. Water in-take
2. Pressure out-line
3. Soap intake
4. Oil Fill\Breather
5. Oil fill plug for
Enigine
Pump Styles may vary
*
*Pump requires 5oz. of
SAE30 non-detergent
SAFETY GUIDELINES
3
GENERAL SAFETY
H. Inspect the entire system for leakage, weaknesses, dam-
age or deterioration before each use.
I. Replace or repair any defective parts before using.
J. Check all fasteners regularly.
K. Do not touch hot surfaces.
L. Shut off the pressure washer immediately if it begins to
vibrate excessively.
M. Do not fill the gas tank indoors and be sure to wipe off
any spilled gas before attempting to start the pressure washer.
N. Stop engine before leaving the area. Never leave a run-
ning unit unattended.
O. Remove spark plug wire while inspecting unit to keep it
from inadvertently restarting.
P. Allow unit to cool before storing.
Q. DO NOT OPERATE WASHER WITHOUT PROPER WA-
TER SUPPLY
4
4
3
2
5
5
3
2
1