Do you have a question about the TTB2700PRW and is the answer not in the manual?
Questions and answers
george whittall
April 21, 2025
How to replace hose on titan prw2700
1 comments:
Mr. Anderson
May 11, 2025
To replace the hose on the Titan TTB2700PRW pressure washer:
1. Ensure the unit is turned off and unplugged. 2. Release pressure by pressing the gun trigger. 3. Disconnect the old hose from the hose reel and the spray gun. 4. Attach the new hose to the hose reel and secure it. 5. Connect the other end of the new hose to the spray gun. 6. Ensure all connections are tight and secure before use.
Always unwind the full hose before operating to prevent damage or injury.
This answer is automatically generated
Joy hudson
February 19, 2025
My Titan pressure Washer TTB2700PRW is pouring water from within the machine and out of the base. The water pressure through the hose is very poor. It was purchased in December 2023 and was last used in October 2024
1 comments:
Mr. Anderson
February 19, 2025
Water leakage from the base of the Titan pressure washer TTB2700PRW could be caused by worn seals. To fix this, contact an authorised service centre. Poor water pressure through the hose could be due to a dirty filter, a blocked hose, or a low water inlet volume. To resolve this, clean the filter, check the hose for blockages, and increase the water inlet quantity.
Need help?
Do you have a question about the TTB2700PRW and is the answer not in the manual?
Questions and answers
How to replace hose on titan prw2700
To replace the hose on the Titan TTB2700PRW pressure washer:
1. Ensure the unit is turned off and unplugged.
2. Release pressure by pressing the gun trigger.
3. Disconnect the old hose from the hose reel and the spray gun.
4. Attach the new hose to the hose reel and secure it.
5. Connect the other end of the new hose to the spray gun.
6. Ensure all connections are tight and secure before use.
Always unwind the full hose before operating to prevent damage or injury.
This answer is automatically generated
My Titan pressure Washer TTB2700PRW is pouring water from within the machine and out of the base. The water pressure through the hose is very poor. It was purchased in December 2023 and was last used in October 2024
Water leakage from the base of the Titan pressure washer TTB2700PRW could be caused by worn seals. To fix this, contact an authorised service centre. Poor water pressure through the hose could be due to a dirty filter, a blocked hose, or a low water inlet volume. To resolve this, clean the filter, check the hose for blockages, and increase the water inlet quantity.
This answer is automatically generated