Optoma ES515 Owner's Manual page 51

Replacing the Lamp
. Loosen the captive screws on the lamp compartment cover.
. Remove the lamp compartment cover.
3. Remove the three screws from the lamp module.
4. Lift the module handle up and disconnect the lamp connector
then pull firmly on the module handle to remove the lamp
module.
5. Reverse steps  to 4 to install the new lamp module. While
installing, align the lamp module with the connector and ensure it
is level to avoid damage.
The lamp module must sit securely in place and the lamp
connector must be connected properly before tightening the
screws.
6. Replace the lamp compartment lid and tighten the captive screw.
After replacing the lamp, the lamp hours counter must be reset.
See page 4 for more information.
Warning:
Lamp Connector must be installed flush with the connector
4
base as shown in the image below. A gap between the Lamp
Connector and the connector base will cause damage to the
projector.
The following images illustrate correct and incorrect Lamp
Connector installations.
No Gap Gap
Correct
Appendices
Incorrect
5
English