Chapter 2 Hardware Installation & Initial Setup; Front Panel Leds Of The P642; Rear Panel And Connections Of The P642; Figure 2-1 Prestige 642 Front Panel - ZyXEL Communications Prestige 642 User Manual

Hardware Installation & Initial Setup
2.1

Front Panel LEDs of the P642

The LED indicators on the front panel indicate the operational status of the Prestige 642. The table below
the diagram describes the LED functions:
PWR
The PWR (power) LED is on when power is applied to the Prestige.
SYS A steady on SYS (system) LED indicates the Prestige is on and functioning properly
while an off SYS LED indicates the system is not ready or a malfunction. The
system is rebooting when the SYS LED is blinking.
LAN 10M
A steady light indicates a 10Mb Ethernet connection. The LED will blink when data
is being sent/received.
LAN 100M A steady light indicates a 100Mb Ethernet connection. The LED will blink when data
is being sent/received.
ADSL The ADSL LED is on when the Prestige is connected successfully to a DSLAM. The
LED blinks when data is being sent/received. The LED is off when the link is down.
2.2

Rear Panel and Connections of the P642

The following figure shows the rear panel connectors of your Prestige.
Hardware Installation & Initial Setup
This chapter describes the physical features of the Prestige

Figure 2-1 Prestige 642 Front Panel.

Table 2-1 Front Panel LED Description

Prestige 642 ADSL Bridge
Chapter 2
and how to make the cable connections
.
2-1