Table of Contents
Advertisement
NOTE!
The option Video Standard makes it possible for you to choose different television standards.
This only makes sense, for example, if you have an NTSC VCR or camera connected to the TV
card. Then you can choose the setting NTSC under the option Video Standard, so that the
delivered signals can be processed correctly. Make sure that a change in the setting from PAL
B,D,G,H,I only occurs under the conditions mentioned. Otherwise the TV signal reception will
be limited.
The Menu Point "Video Format"
Through the menu point Video Format you can determine the size of the picture to be recorded
and the number of bytes that are to be used per pixel.
fig. 12: In this window, determine the size and number of bytes used for recording.
The setting Image Dimensions
Through the point Image Dimensions you can choose from three resolutions for the capturing
of frames and recording of video sequences:
Resolution
Single Frame
192 x 144
384 x 288
768 x 576
TerraTValue
Result
Result Video Sequence
OK
OK
OK
Depending on your system/hard drive capability, it is
possible that dropped frames can occur. For more
information, please read the topic Attention! – Recording
Parameters of Video Sequences in this online manual.
OK
Using this resolution always results in dropped frames.
This is because the incoming amounts of data of around 17
MBytes are more than any hard drive currently available
can process.
31
Advertisement
Table of Contents
