Zibro S1026 Operating Manual page 9

Timer on Button: Press this button to initiate the auto-on time sequence. Each press will increase the
auto-timed setting in 30 minutes increments. When the setting time displays 10Hr, each press will incre-
ase the auto-timed setting 60 minutes increments. To cancel the auto-timed program, continue pressing
the button until nothing displays.
Timer off Button: Press this button to initiate the auto-off time sequence. Each press will increase the
auto-timed setting in 30 minutes increments. When the setting time displays 10Hr, each press will incre-
ase the auto-timed setting 60 minutes increments. To cancel the auto-timed program, continue pressing
the button until nothing displays.
Names and Functions of indicators on Remote Controller
Display Panel
TRANSMISSION Indicator:
This indicator lights when remote controller transmits signals to indoor unit.
MODE indicator:
Displays the current operation modes. Including AUTO
HEAT only available for heat pump model.
TEMPERATURE indicator:
Displays the temperature settings(17ºC to 30ºC).
FAN SPEED indicator:
Displays the selected fan speed, AUTO
Displays (flashing) when the operating mode is either AUTO or DRY.
SLEEP/TURBO indicator:
Each time the Sleep/Turbo button is pushed, the signal displays in the following sequence:
Nothing
Nothing appears when the operating mode is either DRY or FAN only
SWING indicator:
This indicator lights up when the SWING button is pressed.
TIMER indicator:
The time set for timer operation is indicated. (0.5 ~ 24 hours)
NOTE!
All items are shown in the Fig.2 for the purpose of clear presentation But during the actual
operation only the relative functional items are shown on the display panel.
fig. 2
and three fan speed levels LOW
Nothing
, COOL , DRY , HEAT
, MED
or FAN .
, HIGH .
4
109