Monster SUPERTHIN Installation Manual page 9

wood Stud mounting (cont'd)
3
Suspend a straight edge, such as a ruler, across
the top of the mounting plate. Place the
provided level on the straight edge and confirm
that the wall plate is horizontally straight. Hold the
plate firmly in place. Mark the stud center in the top
and bottom mounting holes with a pencil.
4
With your electric drill and ³ ∕ ₁₆ " bit, pre-drill
a 3" deep hole at each mark.
5
Position the wall mounting plate over the holes
drilled in the wall stud. Make sure the wall plate
is level by using the supplied bubble level. Place the
provided level on a ruler placed on top of the wall
mounting plate and confirm that the wall plate is
vertically straight. Hold the plate firmly in place.
9