Monster PowerCenter HTUPS2700 Owner's Manual page 7

WaRnInG – Malfunction and Servicing
If, for any reason, this HTUPS is not operating properly, unplug the unit and consult the Warranty Information sheet
for important details, or contact your original retailer for repair and service information .
WaRnInG – Power Cord Safety
a. When routing the AC power cord, do not place it near areas with heavy foot traffic that would create
a trip hazard (e .g ., hallways, doorways, and floors) .
b. If the power cord's protective jacket begins to rip or fray, exposing the internal wiring, shielding, etc .,
disconnect it from the power source and discontinue use of the HTUPS immediately . See the Warranty
Information sheet for important details .
WaRnInG – De-energizing The HTUPS
To fully de-energize the HTUPS, unplug the unit from the wall outlet, then turn the unit off .
CaUTIOn – exposure To Heat
Do not expose the HTUPS to direct sunlight or place it near wall heaters, space heaters, or any enclosed space prone
to temperature increase .
CaUTIOn – Proper Cleaning
In general, the only cleaning necessary for this HTUPS is a light dusting . Unplug the component from the wall before
cleaning it . Do not use any type of liquid or aerosol cleaners .
fCC ReQUIReMenTS
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules . These limits are designed to provide reasonable protection
against harmful interference in a residential installation . This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications . However, there is no guarantee that interference will not occur in a particular installation . If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or
relocate the receiving antenna, • Increase the separation between the equipment and receiver, • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected,
• Consult the dealer or an experienced radio/TV technician for help.
iii