Monster PowerCenter HTUPS2700 Owner's Manual page 24

Symptom
HTUPS 2700 is not
providing power .
17
TROUbleSHOOTInG
Possible Cause Remedy
HTUPS 2700 is not • Make sure HTUPS 2700's AC power plug is plugged into
turned on . a properly grounded 120V wall outlet . Unit should turn
on right away .
• In some situations, a wall switch may need to be turned on
to send electricity to the wall outlet . Try turning on the light
switches located near the wall outlet powering HTUPS 2700 .
Battery voltage is low . • Verify that the internal battery connection is secure.
(See Instructions on page 11)
• Recharge HTUPS 2700's battery for at least 4 hours.
(Contact your Monster Power dealer if battery does not charge .)
HTUPS 2700 • Please see warranty information.
is defective .
Too many devices are • Press the HTUPS Thermal Circuit Breaker button in to reset.
connected, causing an Please allow 10 minutes before attempting to reset . If you reset
overload, tripping the too soon, the breaker will prematurely sense power overload
Thermal Circuit Breaker . and not allow the PowerCenter to operate .
COn'T