Rf Remote Control Syncing For Multiple Powercenters - Monster High Definition PowerCenter HDP1400G Owner's Manual

Rf Remote Control syncing for Multiple PowerCenters

The GreenPower RF Remote Control can be used with more than one RF Controlled Monster
™
To use the RF remote control for more than one unit, it is necessary to sync its signal to the PowerCenter
1. Plug in the PowerCenter's power cord to a grounded AC outlet . Do not connect any equipment to the PowerCenter's
outlets before syncing the RF remote control .
2. Press the sync button on the bottom of the PowerCenter with the point of a pen or other object and hold down
until you hear a single "beep ." The unit is now in learning mode .
3. With the remote control at least 6" (15 .2cm) from the PowerCenter, press and hold both On and Off buttons
on the RF remote control . The PowerCenter will "beep" twice to indicate that it has learned the RF code .
nOTe: After pressing the sync button (Step 2), the PowerCenter remains in learning mode for 10 seconds . If you do not
sync the remote control within 10 seconds, you must press the sync button again to activate learning mode .
HOOK-UP GUIDe
PowerCenter .
® ™
13