Sub-Zero 424G Installation Manual page 28

MODEL WS-30 INSTALLATION
Placement
CAUTION
Before moving the unit into position, secure the door
closed and protect any finished flooring.
Use an appliance dolly to move the unit near the opening.
If the unit has been on its back or side, it must stand upright
for a minimum of 24 hours before connecting power.
If the unit will be connected to a home security system, run
lead wires through the compressor compartment prior to
positioning the unit. Refer to page 30. Once the unit is in
position, wiring connection can be completed from the front.
Plug the power cord into the grounded outlet, then roll the
unit into position. Verify the anti-tip brackets are properly
engaged.
If used, side panels will need to be
IMPORTANT NOTE:
installed before the unit is placed in its final position. Refer
to page 27.
|
28 Sub-Zero Customer Care 800.222.7820
Alignment
LEVELING
Once the unit is in position, turn the front leveling legs
clockwise to adjust the height. The rear height adjustment
can be made from the front of the roller base. Using a
3
socket, turn the / " hex bolt clockwise to raise the unit or
8
counterclockwise to lower. Use the lowest torque setting
when using a power drill. Do not turn the rear leveling legs
by hand. Refer to the illustration below.
When the unit is properly leveled, door adjustments are less
likely to be necessary.
Level the unit to the floor, not sur-
IMPORTANT NOTE:
rounding cabinetry. This could affect the operation of the
unit, such as door closing.
WARNING
To reduce the possibility of the unit tipping forward, the
front leveling legs must be in contact with the floor.
FRONT
LEVELING LEG
REAR
ADJUSTMENT
Leveling.
3
/ "
8