Sub-Zero 424G Installation Manual page 27

MODEL WS-30 INSTALLATION
Panel Installation
GRILLE PANEL
Remove the bottom grille frame by extracting the lower
two corner screws from each side of the grille assembly.
Refer to the illustration below.
With the bottom section removed, slide the custom grille
panel into the frame. If the panel is thinner than
filler material will need to be installed to achieve a proper
fit. Once the panel is installed, reattach the bottom grille
frame by sliding the corner brackets back into position, then
reinstall the four corner screws.
BOTTOM
GRILLE
FRAME
Grille frame assembly.
SIDE PANEL
When installing a custom side panel, an accessory kit is
required and is available through an authorized Sub-Zero
dealer. For local dealer information, visit the find a show-
room section of our website, subzero.com. Stainless steel
and white enamel side panels are also available from an
1
/ " , a
(6)
4
authorized Sub-Zero dealer.
IMPORTANT NOTE:
width of the opening.
A custom side panel must be a minimum of 24"
1
and / "
(13)
2
panel to fit flush against the side of the unit. Refer to the
illustrations below.
IMPORTANT NOTE:
with the height of the grille. Verify the finished height before
modifying panels.
24"
ROUT TO 1
7
1 /
1"
OPTIONAL
TOE KICK
CUT-OUT
Side panel dimensions.
The use of side panels may change the
thick. Routing will be necessary for the side
The height of the side panel will vary
(610)
FRONT
OF SIDE
PANEL
1
/ "
8 (3)
1
"
8 (48)
84"
(25)
(2134)
Routing detail.
4"
(102)
5
2 / "
8
(67)
deep
(610)
1"
(25)
7
1 / "
8 (48)
/ "
8 (3)
/ "
2 (13)
MAIN SIDE PANEL
FRAME ROUTING
|
subzero.com 27