Adjusting the Registration
!¡ Red ZONE adjustment
86
(GB)
Adjustments
Adjust red ZONE after the red lines have converged with the green lines
by performing the adjustments 6 to !º.
1
Press the ZONE key.
The 9
9 HATCH pattern and the cursor appear.
2
Press the POSITION +/– keys to select the part to be adjusted.
When you press the + key, the cursor moves in the numerical order as
illustrated.
When you press the – key, the cursor moves in the reverse order.
The selected position number appears at the upper right corner.
6
12
14
8
10
18
2
20
16
4
1
5
11
19
3
21
17
7
13
15
9
If you press the ZONE key again in ZONE adjustment mode, you can
move the cursor to the desired position with the V, v, B, b keys. When
you press the ZONE key again after selecting the position, the
projector enters the adjustment mode of that postion.
3
Adjust the red line distortion in the cursor positioning area with the
arrow keys.
4
After the adjustment is complete, press the MEMORY key to save the
adjustment data.
The red registration adjustment is complete.
Proceed to the registration adjustment of the blue signal.