Sony VPH-D50HTU Installation Manual page 39

4 RGB keys
Enter the adjustment mode for the input signal.
APA: This key does not function with this projector.
DOT PHASE: This key does not function with this
projector.
SIZE: Enters the size adjustment mode for the input
signal. Next adjust the size of the picture using the
four arrow keys.
B : to reduce horizontal size
b : to expand horizontal size
V : to expand vertical size
v : to reduce vertical size
Press the MEMORY key 7 to store the adjusted
value and display the adjusted picture.
SIFT: Enters the shift adjustment mode for the input
signal. Next adjust the position of the picture using
the four arrow keys. The picture shifts in the
direction of the arrow on the pressed key.
Press the MEMORY key 7 to store the adjusted
value and display the adjusted picture.
5 COMMAND ON/OFF switch
No keys on the remote control except the LIGHT key
1 function when this switch is set to OFF. This saves
battery power.
6 CENT R/B keys
Enter the centering adjustment mode of the red and
blue.
R: Press to enter the red centering adjustment mode.
B: Press to enter the blue centering adjustment mode.
Perform the centering adjustment using the four arrow
keys.
7 MEMORY key
Stores various adjusted data into memory.
8 ON/STANDBY keys
Turn on and off the projector when the MAIN POWER
switch on the projector is set to ON.
9 Menu operation keys
Used for various adjustment functions and for menu
operations.
MENU: Displays the main menu. Press it again to
turn off the menu.
Arrow keys: Adjusts the value or selects the item in
the menu.
ENTER: Stores the settings in the menu.
!º FUNCTION key
This key does not function with this projector.
!¡ RESET key
Resets the adjusted levels to the factory preset or
service adjusted levels.
!™ POSITION +/– keys
Select the position to be adjusted on the screen in
focus, registration or blanking adjustment mode.
Also, set V SHIFT to WIDE or NARROW in the RGB
input signal's SHIFT adjustment mode.
!£ PICTURE CONTROL keys
Adjust the picture conditions: CONTR (contrast),
BRIGHT (brightness), COLOR, HUE and SHARP
(sharpness).
!¢ VOL +/– keys
These keys do not function with this projector.
! MG FOCUS key
This key does not function with this projector.
!§ FOCUS LENS key
This key does not function with this projector.
!¶ POSITION +/– keys
Function the same as the POSITION +/– !™ keys.
Select the position to be adjusted on the screen in
focus, registration or blanking adjustment mode.
!• W/B (white balance) keys
Enter the white balance adjustment mode.
BIAS: Adjusts cut off.
GAIN: Adjusts drive.
!ª REGISTRATION keys
CENT/SIZE/LIN/SKEW/BOW/KEY/PIN/ZONE
Select the desired item for registration adjustment with
each key, then adjust the item with the arrow keys.
For details, see "Keys for Adjusting" on page 68 (GB).
@º ADJ R/G/B (adjust red/green/blue) keys
Select color to be adjusted when adjusting the focus,
registration and white balance adjustments.
R: Red signal
G: Green signal
B: Blue signal
@¡ CUT OFF keys
Select the color to be turned off when adjusting the
registration. Press again to turn on the color.
R: Red signal
G: Green signal
B: Blue signal
39
Before adjustment (GB)